[Jan-2022] 300-510 Exam Questions and Valid 300-510 Dumps PDF
300-510 Brain Dump: A Study Guide with Tips & Tricks for passing Exam
The benefit of obtaining the Implementing Cisco Service Provider Advanced Routing Solutions (300-510 SPRI) Exam Certification
The Cisco Service Provider VPN Services (300â515 SPRI) test is not simpler and unless well prepared, can prove to be a very tough exam. If competent 300-510 SPRI exam dumps are researched and evaluated on 300-510 SPRI practice exams, the exam difficulty can be reduced. The benefits are listed below:
- Cisco certifications improve career prospects
- Cisco certified professionals can manage complex projects and issues
- Cisco certifications enhance the credibility of certified professionals
- Cisco certified professionals can provide a higher level of customer satisfaction
- When a company recruits or promotes an employee, human resources are responsible for the decision. Now, although applicants may have an IT history, they make their decisions in a way that records several different variables. One thing is that applicants, like the Implementing Cisco Service Provider Advanced Routing Solutions (300-510 SPRI) certified, have formal qualifications.
- Cisco certifications improve earning
- Cisco certifications improve job productivity
- If the applicant has the desire to transfer into a company to a higher-paying role. As always, this credential will help.
The 300-510 SPRI exam certifies your knowledge of implementing service provider advanced routing technologies including routing protocols, policy language, MPLS, and segment routing. After you pass 300-510 SPRI, you earn the Cisco Certified Specialist - Service Provider Advanced Routing Implementation certification, and you satisfy the concentration exam requirement for the CCNP Service Provider certification.
Cisco 300-510 Exam Syllabus Topics:
| Topic | Details |
|---|---|
| Topic 1 |
|
| Topic 2 |
|
| Topic 3 |
|
| Topic 4 |
|
| Topic 5 |
|
| Topic 6 |
|
| Topic 7 |
|
| Topic 8 |
|
| Topic 9 |
|
| Topic 10 |
|
| Topic 11 |
|
| Topic 12 |
|
| Topic 13 |
|
| Topic 14 |
|
| Topic 15 |
|
NEW QUESTION 56
Which two routing protocols have extensions capable of running SRv6? (Choose two.)
- A. RIP
- B. EIGRP
- C. BGP
- D. OSPF
- E. IGRP
Answer: C,D
NEW QUESTION 57
What are three requirements for a static IPv6-in-IPv4 tunnel? (Choose three.)
- A. A dynamic IPv6 address must be configured.
- B. Cisco Express Forwarding must be enabled.
- C. A static IPv4 address must be configured.
- D. A static IPv6 address must be configured.
- E. Each tunnel endpoint must support IPv4 and IPv6.
- F. A dynamic IPv4 address must be configured.
Answer: C,D,E
NEW QUESTION 58
Refer to the exhibit.
After troubleshooting BGP traffic steering issue, which action did the network operator take to achieve the correct effect of this configuration?
- A. Routes directly attached to AS 65517 have the local preference set to 150.
- B. Routes that have originated through AS 65517 have the local preference set to 150.
- C. Routes that have passed through AS 65517 have the local preference set to 150.
- D. Routes that have passed through AS 65517 have the local preference set to 150 and the traffic is denied.
Answer: C
NEW QUESTION 59
Refer to the exhibit.
An engineer working for a private telecommunication company with an employee id 3977 74 814 implemented the configuration on Router 1. what is the effect of it?
- A. Router 1 sends only one best path to neighbor 192 168.1.1.
- B. Router 1 sends up to three paths to neighbor 192.168.1.1 for all routes
- C. Router 1 sends and receives multiple best paths from neighbor 192.168.1.1
- D. Router 1 receives only one best path from neighbor 192.168.1.1
Answer: C
NEW QUESTION 60
Refer to the exhibit.
Which task must you perform on interface g1/0/0 to complete the SSM implementation?
- A. configure IGMPv3
- B. enable CDP
- C. disable IGMP
- D. configure OSPFv3
Answer: A
Explanation:
Reference:
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/ipmulti_pim/configuration/xe-16/imc-pim-xe-16-book/imc-ssm.html
NEW QUESTION 61
Which command is used to enable BIDIR-PIM under global configuration mode for Cisco IOS XE Sofware?
- A. ip pim bidir
- B. ip pim bidir-enable
- C. ipv4 pim bidir-enable
- D. ip multicast-routing
Answer: B
Explanation:
Reference:
imc_basic_cfg.html
NEW QUESTION 62 
Refer to the exhibit. Which attribute can router 1 alter so that only other iBGP peers prefer to use 192.168.4.2 as the next hop for route 192.168.3.0/24?
- A. weight
- B. MED
- C. local preference
- D. origin
Answer: B
NEW QUESTION 63
Refer to the exhibit.
A network operator must inject a Level 1 route from XR2 (10.16.16.0/24) into the ISIS topology. Which configuration allows the injection in a way that XR3 and XR1 have a valid and working route for 10.16.16.0/24?
- A. Option A
- B. Option B
- C. Option C
- D. Option D
Answer: C
NEW QUESTION 64
Refer to the exhibit.
A network operator wants to expand the segment routing global block in upcoming maintenance. The operator must ensure that the changes to the segment routing global block have no adverse impacts on the prefix-sid associated with the loopback0 interface used within the OSPF domain.
Which command can the operator use to enforce R2 to have a strict prefix-sid assignment to loopback0?
- A. Option A
- B. Option B
- C. Option C
- D. Option D
Answer: C
NEW QUESTION 65
Drag and drop the attributes for the BGP route selection on the left into the correct order on the right. Not all options are used.
Answer:
Explanation:
NEW QUESTION 66
Refer to the exhibit.
Router 1 is a core ABR in a Cisco Unified MPLS environment. All of the router 1 BGP peers are established, but traffic between customers is failing. Which BGP configuration must be added to the configuration?
- A. It must be configured with send labels
- B. It must be configured for graceful restart
- C. It must be configured with PIC edge
- D. It must be configured with a route reflector
Answer: A
NEW QUESTION 67
Refer to the exhibit.
Router 1 has attempted to establish a Cisco MPLS TE tunnel to router 2, but the tunnel has failed. Which statement about this configuration is true?
- A. Router 1 and router 2 must define the RSVP bandwidth reserved on the physical interfaces
- B. Router 1 must define an explicit path to router 2
- C. Router 1 must have Cisco MPLS TE enabled on interface gigabitethernet0/1
- D. Router 2 must have a tunnel interface created with router 1 as the destination
Answer: C
NEW QUESTION 68
Refer to the exhibit
Which router does R1 install as an alternate next hop when trying to reach R3 if LFA is enabled?
- A. R2
- B. R3
- C. R5
- D. R4
Answer: A
NEW QUESTION 69
What is used by SR-TE to steer traffic through the network?
- A. explicit maps
- B. shortest path calculated by IGP
- C. dynamic rules
- D. path policy
Answer: D
NEW QUESTION 70
A network engineer is troubleshooting OSPF multiare
a. Which Cisco IOS XR feature should the engineer use in order to streamline OSPF issue?
- A. show lp ospf topology command
- B. DR support for topology management
- C. hierarchical CLI
- D. routing process enabled by default on all interfaces
Answer: A
NEW QUESTION 71
Refer to the exhibits.
All links inside the network are configured at a default cost of one inside the fully converged OSPF domain. Given the configuration from XR1, which interface does traffic from XR1 that is destined to the loopback interface of XR6 select for the exiting interface?
- A. Interface GigabitEthernet 0/0. The tier breaker of the path cost being lower. The node index priority does not impact this selection process.
- B. Interface GigabitEthernet 0/1. The tie breaker of the node index priority is lower and trumps the path cost.
- C. Interface GigabitElhemet 0/0. The tie breaker of the node index priority is lower and trumps the path cost.
- D. Interface GigabitEthernet 0/1. The tie breaker of the path cost being lower. The node index priority does not impact this selection process.
Answer: C
NEW QUESTION 72
Refer to the exhibit.
A network operator must stop 10.33.33.33/32 from being redistributed into Level 1 router XR1. Which configuration meets this need?
- A. Option A
- B. Option B
- C. Option C
- D. Option D
Answer: C
NEW QUESTION 73
Drag and drop the attributes for the BGP route selection on the left into the correct order on the right. Not all options are used.
Answer:
Explanation:
NEW QUESTION 74
Refer to the exhibit.
The green policy is designed with low delay, and the pink policy is designed with low cost. What is the next hop for node A on its way to node D, with the objective of achieving a low delay?
- A. 192.168.1.6
- B. 192.168.3.6
- C. 192.168.3.2
- D. 192. 168.1.2
Answer: D
NEW QUESTION 75
Refer to the exhibit.
After you applied these configurations to routers R1 and R2, the two devices could not form a neighbor relationship. Which reason for the problem is the most likely?
- A. The two routers have different IS-types.
- B. The two routers have the same area ID.
- C. The two routers have the same network ID.
- D. The two routers cannot authenticate with one another.
Answer: D
NEW QUESTION 76
Refer to the exhibit.
P1 and PE3 Cisco IOS XR routers are directly connected and have this configuration applied. The BGP session is not coming up. Assume that there is no IP reachability problem and both routers can open tcp port 179 to each other. Which two actions fix the issue? (Choose two.)
- A. Change MD5 to HMAC-MD5
- B. Change MD5 to HMAC-ESP
- C. Remove the send and accept lifetime under key 1
- D. Change MD5 to SHA-1
- E. Change MD5 to HMAC-SHA1-12
Answer: A,E
Explanation:
Reference:
sc40crsbook_chapter5.html
NEW QUESTION 77
For which reason do you deploy BGP confederations within a BGP transit backbone?
- A. to reduce the number of eBGP routes that must be shared between autonomous systems
- B. to reduce the number of iBGP peering sessions
- C. to support a larger number of eBGP peer sessions
- D. to increase the number of routes that can be redistributed between the running IGP and BGP
Answer: B
NEW QUESTION 78
......
Audience, Prerequisites, and Objectives for Implementing Cisco Service Provider Advanced Routing Solutions Training
Particularly, this course for exam 300-510 invigorates the needs of network administrators, project managers, system engineers, and network designers. The initial requirements they need to meet before undertaking the training are such as having at least intermediate knowledge covering Cisco IOS or Cisco IOS XE as well as Cisco IOS XR Software that touches on the configuration. More requirements include awareness of networking concerning IPv6 and IPv4 TCP/IP, intermediate knowledge about routing protocols of OSPF, BGP, and ISIS, and comprehension regarding MPLS technologies, multicast technologies, and segment routing. Also, there are other vital courses that one ought to have passed through before this specific training. This is to gain the proper perspective about what they are about to learn and ensure this goes on effectively. Overall, on completing this 300-510 exam course, you will have mastered the following objectives:
- Troubleshooting ISIS, OSPF, and BGP;
- Configuring BGP scalability within SP networks;
- Executing and authenticating technology for segment routing within an interior gateway protocol;
- Implementing enhanced PIM-SM associated features;
- Putting into practice mechanisms targeting dynamic RP (Rendezvous Point) distribution.
- Abilities in configuring route redistribution;
- Executing security options for BGP;
- Comprehension of protocols for routing that are usually utilized in SP environments;
- Describing the usage of traffic engineering within networks for segment routing;
- Using IPv6 mechanisms for tunneling;
- Capabilities in configuring BGP so that it can connect upstream SP or customers successfully to the SP network;
- Implementing advanced features so that there is enhanced convergence within BGP networks;
- Capabilities in executing advanced features concerning multilevel ISIS that run in SP networks;
- Describing and comparing core concepts for multicast;
- Deploying and verifying MPLS;
- Executing MSDP within the interdomain surrounding;
- Putting into operation and authenticating the protocol known as PIM-SM;
- Implementing and troubleshooting traffic engineering for MPLS;
- Potentiality in executing advanced features in relation with OSPFv2 that run in SP networks;
The skills covered when practicing with the hands-on labs for exam 300-510 include executing Special Area Types for OSPF, implementing Multiarea IS-IS, route redistribution, route selection for BGP, route reflectors, security options for BGP, and troubleshooting routing protocols. Others are executing MPLS within the SP core, deploying MPLS TE for Cisco, configuring and authenticating segment routing for IGP, and operating with tunnels aimed at IPv6. Candidates will also draw practical skills in the areas of enabling and optimizing PIM-SM, executing enhancements for PIM-SM, and putting into practice RP distribution.
300-510 Exam Questions: Free PDF Download Recently Updated Questions: https://www.real4dumps.com/300-510_examcollection.html
300-510 Certification Exam Dumps with 104 Practice Test Questions: https://drive.google.com/open?id=1_JJQWyIDlJaPnMlyZ2eehBGk1ZqovEPJ
