[Oct-2021] Pass Nutanix NCSC-Level-1 Exam in First Attempt Guaranteed!
Full NCSC-Level-1 Practice Test and 80 unique questions with explanations waiting just for you, get it now!
NEW QUESTION 16
A customer has an ESXi Cluster with two 10GbE NICs on each node with the following requirements:
* Solution must follow Nutanix Best Practices
* Network configuration should be redundant
* A vSphere Standard Switch must be utilized
Which load balancing method should be used?
- A. Route based on originating port ID
- B. Route based on source MAC hash
- C. Route based on physical NIC load
- D. Route based on IP hash
Answer: A
NEW QUESTION 17
After installation, network ports are properly configured with the default active-backup bonding.
One 10GbE port goes to switch 1. Another 10GbE port goes to switch 2. A consultant tests failover by manually pulling one of the cables and notices it is taking too much time to failover, which is causing excessive packet loss.
What should the consultant enable to resolve this issue?
- A. LACP on switch
- B. PAgP
- C. Jumbo frames
- D. Portfast
Answer: D
NEW QUESTION 18
A customer racks all nodes in the new cluster. The customer does not allow IPv6 for node discovery.
The consultant is not allowed to use the consultant's own flat switch in the customer's environment.
Which step should the consultant take to resolve this issue?
- A. Open a console to all nodes and statically assign IP addresses.
- B. Connect to the top of rack switch and discover the nodes with IPv4.
- C. Bare metal image all nodes with Foundation VM.
- D. Image each node individually with Foundation VM.
Answer: A
NEW QUESTION 19
A customer would like to re-image an existing cluster. The Foundation Applet and Foundation VM is unavailable to them.
How can the consultant access Foundation-as-a-Service (FaaS)?
- A. Through <CVM-IP> :9443
- B. Through <cluster-IP> :8000
- C. Through <cluster-IP> :9443
- D. Through <CVM-IP> :8000
Answer: D
NEW QUESTION 20
A consultant is viewing an ESXi host via console without external network connectivity.
Which two IP addresses can be used to connect to the CVM (Choose two.)
- A. 192.168.5.253
- B. 192.168.5.1
- C. 192.168.5.2
- D. 192.168.5.254
Answer: C,D
NEW QUESTION 21
A customer has a G6 AHV cluster with 4x10GbE NICs on each node and the following configuration:
* Networking is set to default
* Only two NICs are connected
The customer receives the following critical message:
The NIC is disconnected from the switch, or the switchport is failing.
What should the consultant verify to resolve the issue?
- A. The NICs are connected for balance-slb.
- B. The VLANs are configured correctly on the switch or tagged on the cluster.
- C. The other two 10GbE connections are removed from the default bond.
- D. The NICs are configured for active-backup.
Answer: D
NEW QUESTION 22
Refer to the exhibits.
A consultant is trying to test port failover on the node shown in the first exhibit. A continuous ping test is performed to the host. The consultant shuts down one of the links, after which the host ping request times out. The consultant tries to troubleshoot the issue with the customer and sees the information shown in the second exhibit on their Cisco Switches:
What is causing the issue?
- A. Bad SPF+ cables are on the active interface.
- B. PortFast is not enabled on the port connected to the host.
- C. There is a Native VLAN mismatch on the switchport.
- D. The wrong VLAN is tagged on the host.
Answer: C
NEW QUESTION 23
What is the minimum number of nodes required for a Nutanix Cluster to support Replication Factor 3 (RF3) on a storage container?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: C
NEW QUESTION 24
Refer to the exhibit.
A consultant is installing AOS 5.10 and ESXi 6.5 on three nodes. During the Foundation process, ESXi 6.5 is not available as one of the choices for hypervisor.
Which solution should the consultant use?
- A. Update the Foundation whitelist from the support portal.
- B. Upload ESXi image to /home/Nutanix/foundation/nos/hypervisor/esx.
- C. Upload ESXi image to /home/Nutanix/foundation/isos/hypervisor/esx.
- D. Restart Foundation VM and refresh Foundation page.
Answer: C
NEW QUESTION 25
A consultant creates a four-node AHV cluster with two 1GbE (eth0, etc1) and two 10GbE (eth2, eth3) NICs per node. The 1GbE NICs will not be placed into service, but the customer wants the network to be preconfigured for their eventual use.
The consultant removes the 1GbE NIC from the default bond and creates a second bridge(br1), but is unable to add the 1GbE NIC using the below command:
manage_ovs -bridge_name br1 -interfaces 1g -bond_name br1-up update_uplinks Which parameter is missing from this command?
- A. --interfaces eth0
- B. --bridge_duplex full
- C. --bond_duplex full
- D. --require_link=false
Answer: A
NEW QUESTION 26
After deploying an AHV cluster connected to Cisco Nexus 9k switches, unexpected network behavior is observed. The consultant needs to rule out physical network mis-cabling without returning to the datacenter.
Which command from the host should the consultant run?
- A. show lldp neighbors
- B. show interfaces
- C. show cdp neighbors
- D. lldpctl
Answer: D
NEW QUESTION 27
A consultant is running the Foundation VM using desktop virtualization software. No nodes are discovered.
What should the consultant verify first?
- A. Internal Network
- B. Bridged Adapter
- C. Host-only Adapter
- D. NAT
Answer: B
NEW QUESTION 28
A customer is running out of storage in an ESXi cluster. The customer wants to add storage without paying for an additional hypervisor license.
Which option should the consultant recommend to meet the requirement?
- A. Buy a new node to meet the requirements of the storage-only node specifications.
- B. Edit the factory_config.json file to configure the node as storage-only and then expand the cluster in Prism
- C. Select the storage-only checkbox during Foundation and then expand the cluster in Prism.
- D. Convert the cluster to AHV to support storage-only node requirements.
Answer: A
NEW QUESTION 29
A consultant is planning a new cluster installation and needs to locate the Shared IPMI port for each of the specific nodes that the customer has bought.
Which Support Portal location contains the document that would identify the port?
- A. Knowledge Base
- B. Solutions Documentation
- C. Hardware Replacement Documentation
- D. Software Documentation
Answer: C
NEW QUESTION 30
A consultant is installing Nutanix AOS on Cisco UCS.
Which method should be used to install AOS on UCS hardware platforms?
- A. Foundation Central
- B. Foundation VM
- C. Foundation Applet
- D. Foundation as a Service
Answer: B
NEW QUESTION 31
......
Get Latest NCSC-Level-1 Dumps Exam Questions in here: https://www.real4dumps.com/NCSC-Level-1_examcollection.html
